CANOGA PERKINS 6703 CWDM Transponder - Manual (Page 21)

EdgeAccess Universal Chassis System
HOST TABLE
Managing Access Trap Trap Managing Access Trap Trap
Host Level Community Port Host Level Community Port
----------------------------------- ----------------------------------
172.16.142.20 4 public 162
172.16.142.3 4 public 162
192.0.0.3 4 public 162
Add or Delete a host entry (1=Add, 2=Delete from table):
Figure 11. Host Table Screen
3.5 Configuration/Status Screen
The Configuration/Status report and menu provide information about the switches set in hardware,
with options to set software control. To access the Configuration/Status screen, follow these steps:
1. From the Main Menu, type 2 , "Configuration/Status," and press <Enter>. The
Configuration/Status screen appears; see Figure 12 and Tables 5 and 6.
2. To set the CDR or SpeedCop option and rate, type 1 and press <Enter>. The Clock Data
Recovery/SpeedCop screen appears; see Figure 13.
a. Type 1 and press <Space> to cycle through these options, then press <Enter>:
• CDR Local RX: Checks and reclocks data rate on the Local Rx toward Remote Tx
• CDR Remote Rx: Checks and reclocks data rate on the Remote Rx toward Local Tx
• CDR Local & Remote Rx: Checks and reclocks data rate on both Local Rx and Remote Rx
• SpeedCop Local Rx: Checks the maximum data rate on the Local Rx toward Remote Tx
• SpeedCop Remote Rx: Checks the maximum data rate on the Remote Rx toward Local Tx
• CDR & SpeedCop Local Rx: Checks the maximum data rate and reclocks the data rate on
the Local Rx toward Remote Tx
• CDR & SpeedCop Remote Rx: Checks and reclocks data rate on Remote Rx toward Local Tx
• Disabled: Does not check data rate or reclock data
b. To select the data rate, type a number from 2 to 24, or type A to auto detect the rate, then
press <Enter>. Standard data rates include those for Ethernet/SAN, SONET/SDH, and digital
video. Use selections 2 through 9 to define up to eight data rates to reclock, in Mbps.
c. To return to the Configuration/Status screen, press <Esc>.
3. At the Configuration/Status screen, type the number for a control item and press <Enter>, then
press <Space> to cycle through the options, and press <Enter> to select an option. See Table 6.
4. To return to the Main menu, press <Esc>.
CWDM Transponder Model 6703 3-9