CANOGA PERKINS 6703 CWDM Transponder - Manual (Page 25)

EdgeAccess Universal Chassis System
Table 8. Utilities Menu Options
Item Definition
1) Set Date and Time Change the time and date information for the 6703 if needed; if
in a chassis with a DMM, the DMM date and time overrides
the 6703; if the 6703 loses power, it loses the Date and Time
2) New Password Add, delete, or update the password for the user interface; type
the new password, then confirm it at the prompt; after you log
out, the new password will be required the next time a user
tries to access the 6703 module
3) Modem/Slip/PPP Baud
Rate Set the baud rate, 9600, 19200, 38400, 57600, or 115200 bps
for the modem/SLIP/PPP serial port
4) Modem Initialization String The default string is "AT"
5) Reset Configuration To
Default Restores all configurable settings to the defaults except for:
date and time; password; BOOTP; Telnet timeout
6) PING Generation Access the PING diagnostics screen
3.7 PING
Use the PING Generation screen to test the connection to a specific IP address. See Figure 16.
PING Generation
IP Address to PING: 0.0.0.0
PING count (1 to 255, 0 = forever): 0
Figure 16. PING Generation Screen
To use the PING option, follow these steps:
1. From the Main Menu, type 4 , "Utilities," and press <Enter>.
2. From the Utilities menu, type 6 , "PING Generation," and press <Enter>.
3. At the prompt, type the IP address to PING and press <Tab>.
4. At the prompt, type the number of times to send a PING, from 1 to 256, or type 0 to PING
continuously every 3 seconds, and press <Enter>.
"PING response received..." indicates a good connection;
"TIMEOUT: Unable to reach [IP address]..." indicates a faulty connection.
5. To stop the PING and return to the Utilities menu, press <Esc>.
CWDM Transponder Model 6703 3-13