CANOGA PERKINS N525 Ethernet Termination Service Unit - Manual (Page 43)

N525 Ethernet Termination Service Unit 3-25
Manage Traps
Traps are SNMP messages that are sent to CanogaView or your Management Platform, and
the N525 System Log. Use the Trap Configuration Menu to view the current configuration and
to enable or disable traps. For a list of events that trigger traps, see Table 3. To set up the
traps, follow these steps:
1. From the System Configuration Menu, type [ 2 ], "Trap Configuration," and press <Enter>.
2. At the Trap Configuration Menu, type the number for a trap and press <Enter>. Pressing
<Space> cycles between Log Only, Send Only, Both Log and Send and Disabled. Press
<Enter> to select your choice. Defaults are 1) Master Trap Control: Log Only, all others
(2-13): Both Log and Send.
3. To return to the Main Menu, press <Esc>.
These selections do not affect how the Major and Minor events are reported. Table 3 describes
Trap functions.
Table 3 – T rap Configuration Options
Trap When enabled, sends a Trap if. . .
Local/User Port Link, Remote User
Port Link, or Extension Port Link The link went down and came back up
Remote Fault Received A port receives an RMTF
Link Loss Forwarding A port loses a received link and transmits
notification to the next port
Cold Start The N525 is reset by a power failure or forced reset
Authentication An unauthorized host attempts SNMP access
Side Band Mgmt Channel SBMC is lost or back online
Diagnostics Loopback is enabled or disabled
Configuration When the N525’s remote unit has an incompatible
firmware
Power Supply When the power supply is failing
SFP An SFP change occurs
-----------------------------------TRAP CONFIGURATION---------------------------
1) Master Trap Control Log Only
2) Local User Port Link Traps Both Log And Send
3) Remote User Port Link Traps Both Log And Send
4) Extension Port Link Traps Both Log And Send
5) Remote Fault Received Traps Both Log And Send
6) Link Loss Forwarding Traps Both Log And Send
7) Cold Start Traps Both Log And Send
8) Authentication Traps Both Log And Send
9) Side Band Mgmt Channel Traps Both Log And Send
10) Diagnostics Traps Both Log And Send
11) Configuration Traps Both Log And Send
12) Power Supply Traps Both Log And Send
13) SFP Traps Both Log And Send
Select [1-13]:
------------------------------------Messages------------------------------------