CANOGA PERKINS 9145E Ethernet Network Interface Device Hardware - Manual (Page 25)

Functional Description 9145E Ethernet Network Interface Device User’s Manual
LED Indicators
13/(14 Blank)
2.7.2 Data Interface Section LEDs
Table 2-5 represents the indications supplied by the SPD and LNK/ACT LEDs of the User, Net-
work, and Multipurpose ports. Indications apply to both the SFP and UTP LEDs.
Table 2-4. User, Network, and Multipurpose Port LED Indicators
LED Name State Condition
SPD
Off
10BaseT
Auto
Connector Not Selected
Green 1000BaseT
Amber
100BaseT
System Test
Red Remote Fault (SFP Only)
Blinking Red Invalid/Unsupported SFP installed (SFP Only)
Slow Blinking Green* Connector Selected with No Link
LNK/ACT
Off
No link
No transmit or receive activity
Green Link on with full duplex
Blinking Green Transmission or receiving activity with full duplex
Amber
System test
Link up with half duplex
Blinking Amber Transmission or receiving activity with half duplex
Red
Port Disabled
LLF
Blinking Red No Link, but transmitting OAM packets in unidirectional mode
* Slow Blinking Green means the LED toggles between OFF and GREEN approximately once per
second.