CANOGA PERKINS 9145E Ethernet Network Interface Device Hardware - Manual (Page 27)

Installation 9145E Ethernet Network Interface Device User’s Manual
9145E Installation Procedures
15
3.1 9145E Installation Procedures
This section describes how to unpack, install, and set up the 9145E. Before setting up the 9145E,
make sure a 9 pin EIA-232 cable is available to connect the 9145E's console port to a VT100
type terminal or PC for setup and configuration.
Keep the shipping container and all packing materials until the unit is installed and fully opera-
tional. In the event that the unit needs to be returned, contact Canoga Perkins Customer Service
for a Return Authorization Number (RMA) and instructions for return shipment.
CAUTION: Follow electrostatic discharge (ESD) safety precautions when
handling Canoga Perkins products, as with all electronic devices
with static sensitive components.
3.2 Unpacking
Open the shipping container, remove the accessories tray, and remove the accessories from the
tray (see Figure 3-1). Lift the 9145E out of the shipping container and remove the foam end caps
from the unit. Return all packing materials to the shipping container and put it in a safe place in
the event the unit needs to be returned.
Chapter 3
Installation