DVR systems DVR-HDE-960H-960H2 Series - Manual (Page 125)

Default Route of the device should be in the same network segment as that of the LAN IP address of the
router.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the UPnP™ tab to enter the UPnP™ interface.
Figure 9.16 UPnP ™ Settings Interface
3. Check checkbox to enable UPnP™.
4. Select the mapped type to Auto or Manual.
When you select Auto, the mapping ports can be automatically assigned by the router. When you select
Manual, you should continue Step5 to edit the mapping ports.
5. Click to open the External Port Settings dialog box. Configure the external port No. for server port,
HTTP port and RTSP port respectively.
Notes:
1) You can use the default port No., or change it according to actual requirements.
2) External Port indicates the port No. for port mapping in the router.
Figure 9.17 External Port Settings Dialog Box
6. You can click Refresh to get the latest status of the port mapping.
124