DVR systems DVR-HDE-960H-960H2 Series - Manual (Page 50)

then the file will not be deleted. The actual keeping time for the file should be determined by
the capacity of the HDD.
•
Redundant Record: Enabling redundant record means you save the record files in the
redundant HDD. See Chapter 5.8 Configuring Redundant Record.
Note: The Redundant Record option is only available when the HDD mode is Group. The
redundant record is to decide whether you want the camera to save the record files in the
redundant HDD. You must configure the redundant HDD in HDD settings. For detailed
information, see Chapter 10.4.2 Setting HDD Property.
•
Record Audio: Check the checkbox to record the sound, or uncheck to record the image
without sound.
•
Enable 960Mode: Enable the encoding at WD1 (PAL: 960×576, NTSC: 960×480) resolution.
You can also uncheck the checkbox to disable it.
Note: This feature is available for supported by 960H models only.
5) If you want to copy the current main stream settings to other camera (s), click Copy to enter the
Copy Camera interface. Select the camera (s) and click OK to finish the copy settings.
Figure 5.4 Copy Camera Settings
6) On the Record settings interface, click Apply to save the settings.
Note: You can click the Restore button to restore the current main stream settings to the default
parameters.
3. Set encoding parameters for sub-stream
1) Click the Substream tab to enter the Substream settings interface.
Figure 5.5 Encoding Parameters-Sub-stream
2) Configure the parameters for the sub-stream. Refer to the step of main stream settings.
3) Click Apply to save the settings.
Note: You can click the Restore button to restore the current sub-stream settings to the default
49