Troubleshooting procedure, Summary – Panasonic NN46240-710 User Manual
Page 135
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Troubleshooting - VPN___________
4 MPLS L2VPN troubleshooting
0
Disable
1500
0
VC Type
: atm aal5 sdu
Destination
: 2.2.2.2
Local VC Label
: 119811
Remote VC Label
Control Word
Local VC MTU
Remote VC MTU
Tunnel Policy Name
Traffic Behavior Name
PW Template Name
Create time
UP time
Last change time
[PE-Atm2/1/0.100] return
<PE> reset pw 100 atm-aal5-sdu
pwt1
0 days,
0 hours,
0 minutes,
4 seconds
0 days,
0 hours,
0 minutes,
0 seconds
0 days,
0 hours,
0 minutes,
4 seconds
# Display the configuration and find that the IP address of the PW peer changes:
<PE> display mpls l2vc 100
Total ldp vc : 1
0 up
1 down
*Client Interface
Session State
AC Status
VC State
VC ID
VC Type
Destination
Local VC Label
Remote VC Label
Control Word
Local VC MTU
Remote VC MTU
Tunnel Policy Name
Traffic Behavior Name
Atm2/1/0.100
down
up
down
100
atm aal5 sdu
3.3.3.3
119811
0
Disable
1500
0
PW Template
Name
: pwt1
Create time
: 0 days,
0 hours,
0 minutes,
53 seconds
UP time
: 0 days,
0 hours,
0 minutes,
0 seconds
Last change
time
: 0 days,
0 hours,
0 minutes,
53 seconds
Troubleshooting procedure
Step 1
Create a PW template and set PW attributes (especially those that need change) on it.
Step 2
Apply the PW template to the PW.
Step 3
Run the
reset pw template
command or the
reset pw vc-id
command in the user view to
modify PW attributes.
—End
Summary
The
reset pw template
command or the
reset pw
vc-id command can only change the
attributes that are set by using the PW template.
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
4-25