Projecting with the setting you desire, Av/rgb selection, Using with the picture menu of your – Panasonic TC-LT1 Series User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Projecting With the Setting You Desire
AV/RGB Selection
(Projector)
(Remote Control)
OR
To switch inputs press the AV/RGB switching button on the projector, or the
remote control. Inputs will be switched in the following order:
Signals from the device connected to
AV1 Input will be projected.
Signals from the device connected to Signals from the device connected
AV2 Input will be projected.
to the RGB Input will be projected.
Please do not connect cables to the S-Video Input Terminal if you wish to project a video signal from the video
input terminal.
At the time of shipment, the default colour projection for Auto or RGB input is set to Auto. If the images are not
being projected correctly, however, it may be necessary to change the setting to match the input signal.
Piease see p. 23 for selection of colour standard for the video input signal. Please p. 25 for selection of mode
for the RGB input signal.
Using with the Picture Menu of Your
Remote Control Pressing the Picture Menu Button on the remote control wilt switch
Standard picture
Soft Picture
Bright Picture
20
• The selected Picture Menu will be memorized for each input switching.
• The contents of the Picture Menu (colour, contrast, etc.) let you make the desired changes. (See page 21,
I i.