Remarks on system installation, System examples, Connecting to av equipment – Panasonic TC-LT1 Series User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
System Examples
Remarks on System Installation
• Please read the User Manuals carefully for any equipment you intend to connect to the Projector.
• Make sure that the power is off for each piece of equipment before connecting any cables.
• If the included cables cannot be attached because of the location in which the projector is installed, please use
commercially sold cables that match the equipment to be connected.
• The signals that can be connected to the projector are video signals, S-Video Signals and Analog RGB Signals (with
synchronous signals of 0.6 - 8.0 Vp-p).
• The projector has one 1 W internal speaker. A separate audio system would be required to output high volumes, or to
enjoy stereo sound (please connect each device directly to the audio system).
• Some computer models cannot be connected to the Projector,
Connecting to AV Equipment
Video
• The S-Video In terminal will have priority when cables are connected to both the S-Video In and the Video In
terminals. Please do not connect a cable to the S-Video In if you wish to project video signals.
• If the video signal is to be connected using a BNC plug cable, please use a (commercially sold) BNC-Pin Adapter
if you wish to convert to a pin jack.
• The left audio and the right audio for the Video Input are combined within the Projector into monaural audio.
12