Panasonic AW-PH650 - Manual (Page 11)

Parts and theirfunctions
■AC adapter unit
© ©
<The inside of AC adapter> Q
©
© © o
QDC power unit
This unit supplies a DC output of15 V,10A (maximum)
when an AC input of 220 to 240 V is supplied.
©Power switch [POWER ON/OFF]
This switoh is used to supply AC power to the DC power
unit. Keep the switoh in the ON position during use.
©Fuse hoider/fuse
A fuse for proteoting the DC power unit is in the fuse
holder. A burnt fuse may be oaused by a DC power
unit defeot. In suoh a ease, oonsult the store where you
purohased it.
o Power LED
This lights up red when the power switoh © is at ON.
This is off when the power switoh © is at OFF.
©Cover fastening screws (X2)
To ensure safety, be absolutely sure to tighten up these
sorews and olose the oover upon oompletion of the
installation work.
©Cover
Loosen the two oover fastening sorews © and open the
oover to prooeed with the oonneotions. When olosing the
oover, first olose the oover, and then be absolutely sure to
tighten up the two fastening sorews.
Sinoe malfunotions or other trouble may result if the
sorews are not tightened enough, be absolutely sure to
use a sorewdriver to tighten them up.
©AC power input terminai board
This terminal board is for oonneoting AC input power.
(AC 220 to 240 V, 50 Hz,120 W)
©AC adapter mounting screw hoies (X4)
Attaoh the supplied pole mounting plate to these sorew
holes when the AC adapter is to be mounted on a pole or
other support.
©DC output connector [DC15 V OUT]
Conneot this oonneotor to the [POWER] oonneotor on the
main unit using the supplied power oable.
©Ventiiation opening
©AC power input cabie [AC iN]
This is the AC power input oable. It is held in plaoe by the
fixed bushing.
10(E)