Installation – Panasonic AW-PH650 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
© Check whether the ^^"-shaped part of the lens holder
attached to the bottom of the lens Is Inside the elongated
hole of the metal bracket Inside the housing. If It Is not
Inside, lift the lens slightly, and put It back again.
Also visually check from the front of the housing whether
the centres of the lens and camera are aligned. If they
deviate significantly, turn the lens up/down position
adjustment screw on the lens holder to move the
lens position up or down. (When the screw Is turned
clockwise, the lens position moves up; conversely, when It
Is turned counterclockwise. It moves down.)
Check whether the centre of the
@ Connect the camera with the lens to the Interior of the
housing using the cable.
(Refer to the section on the connections.)
@ Bring the front edge of the lens and Inside of the glass
as close together as possible. Bear In mind the following
points.
(1) Set to a position where the lens and glass will not
come Into contact when the lens Is maximally zoomed
out.
(2) Checkthat the Inside surface of the glass and lens
glass surface are more or less parallel with each
other and that the thermostat sensor and lens do not
touch.
@ Upon completion of all the settings, securelytighten up
the 4 camera mount screws.
@ Close the top cover, and tighten the two bolts for opening
and closing the top cover securely.
of the lens holder is fitted into the
metal bracket.
22 (E)