Cpu circuit board switch settings, Installation – Panasonic AW-PH650 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
■CPU circuit board switch settings
Set switches SW1, SW2 and SW3 on the CPU circuit board as follows.
® SW1 (Selector switch for landing characteristics)
For a soft landing:
Set SW1 to the left position (RP501). (Factory setting)
For an exact landing: Set SW1 to the right position (RP605).
@ SW2
Do not change the position of this switch. Continue to use it at the DESK TOP position.
@ SW3
Do not change the position of this switch. Continue to use it at the RS-422 position.
• Before setting these switches, be absolutely sure to turn off the power of the AC adapter connected to the pan/tilt head.
•The switch settings are not changed simply by changing the position of the switches.
After changing the position of a switch, turn the power off and then back on to actually change the setting of that switch.
15(E)