Panasonic CQ-C8300U - Manual (Page 61)

Overview
This product should be installed by a professional.
However, if you plan to install this product yourself,
your first step is to decide where to instaii it. The
instructions in these pages will guide you through
the remaining steps:
(Please refer to the “WARNING” statement.)
• Identify and label the car wires.
• Connect the car wires to the wires of the power
connector.
• Install the unit in the dashboard.
• Check the operation of the unit.
If you encounter problems, please consult your
nearest professional installer.
Before you begin installation, look for the items
which are packed with your unit.
• Warranty Card... Fill this out promptly.
• Panasonic Servicenter List for Service
Directory... Keep for future reference in case the
product needs servicing.
• Installation Hardware... Needed for in-dash
installation.
Dashboard Specifications
Thickness Min. (4.75 nim)
Max. 4 z 2 (5.56 mm)
• We strongly recommend that you wear gloves
for installation work to protect yourself from
injuries.
• When bending the mounting tabs of the
mounting collar with a screwdriver, be careful
not to injure your hands and fingers.
Disconnect the cable from the negative © battery
terminal (see caution below).
Unit should be installed in a horizontal position
with the front end up at a convenient angle, but
not more than 30".
Less than 30"
Caution:
• If your car is equipped with air bag and/or
anti-theft systems specific procedures may
be required for connection and disconnection
of the battery to install this product.
• Before attempting installation of this
electronic component contact your car
dealer or manufacturer to determine the
required procedure and strictly follow their
instructions.
• FAILURE TO FOLLOW THE PROCEDURE MAY
RESULT IN THE UNINTENDED DEPLOYMENT
OF AIR BAGS OR ACTIVATION OF THE
ANTI-THEFT SYSTEM RESULTING IN DAMAGE
TO THE VEHICLE AND PERSONAL INJURY.
Note:
•Various settings that have been stored in the
memory in other on-board equipment (car
navigation etc.) may be lost if the battery
terminals are disconnected.
Therefore, we recommend to make a record of
or to back up the settings before disconnecting
the terminals.
After completing installation of the main unit,
set the equipment again according to the
record.
Dashboard Installation
Installation Opening
2 4 n (53 mm)
7V s 2" (182 mm)
This unit can be installed in any dashboard having
an opening as shown above. The dashboard should
be V ie " (4.75 mm)-V
32
" (5.56 mm) thick in order to
be able to support the unit.
CQ-C8400/8300/8200/81OOU
61