Panasonic SC-CH84M - Manual (Page 25)

Series playback
To find the beginning of a program
(TPS: Tape Program Sensor)
Press or while the tape is play­
ing.
If the forward side (►) is playing:
►►/►w: The tape will play from the beginning of the next tune.
t
«/«: The tape will rewind to the beginning of the present tune.
Then the tune will play again.
if the reverse side (◄) of the tape is playing:
The reverse operation should take place.
IglSBI
TPS is a function that searches for the silent passage in a tape
program. So, it may sometimes fail to operate correctly in the follow­
ing situations.
•When there is no blank space between tape programs (for exam­
ple, a tape recorded from a microphone)
•When the interval between programs is less than 4 seconds
•When there Is a particular low-level passage in a program (for
example, classical music)
•When the program is less than 10 seconds, or when it is less than
10 seconds from the beginning of the program to the beginning of
the next program
•When a tape is recorded with fade-ins or fade-outs
Press A OPEN on decks 1 and 2, and then insert the tapes.
Insert the tape in deck 1 with the side that you wish to listen to first
facing you.
Press DOLBY NR if the cassette you want to play was recorded
using Dolby noise reduction mode.
Press REV MODE to select “c*3” mode.
Press TAPE DECK 1/2 to select deck 1.
“DECK 1” will light up.
Press ►.
( 1 ) Forward side of tape in deck 1 <----
( 2 ) Reverse side of tape in deck 1
i
(D Forward side of tape in deck 2
i
@ Reverse side of tape in deck 2-
•After repeating above operation 8 times, the tape will automatically
stop.
•You can also start playback from a position other than the forward
side in deck 1 ((T)). In this case, too, the deck counts 1 time after
finishes playback of the reverse side of tape in deck 2 (®).
To stop tape playback:
Press ■ .
For your reference
You cannot select Dolby NR for one deck but not the other. We
recommend you use tapes of the same type (Dolby noise reduction).
About Dolby Noise Reduction system
Using Dolby NR reduces tape hiss in the high-frequency range. It
boosts the level of the high-frequency during recording, and lowers it
by the same amount during playback, simultaneously reducing high-
frequency Interference incurred during the recording process.
Noise is reduced to about one-third.
Use this system when playing back tapes recorded by the Dolby-B
noise-reduction system, such as prerecorded music tapes, etc.
Dolby noise reduction manufactured under license from Dolby
Laboratories Licensing Corporation.
“DOLBY” and the double-D symbol □□ are trademarks of
Dolby Laboratories Licensing Corporation.
To fast-forward or rewind the tape
Press or while the tape is in the
stop mode.
If the forward side (^) of the tape is selected:
►►/►W: Thetape will be fast forwarded.
The tape will be rewound.
If the reverse side (◄) of the tape is selected:
The reverse operation will take place.
25