Panasonic SC-CH84M - Manual (Page 28)

RecomhgM^^^
1
2
DECK 2 Press ^ OPEN on deck 2, and
then insert the tape.
Close the holder.
DOLBY NR
When making a Dolby NR re­
cording, press DOLBY NR so
that the Dolby NR indicator
lights.
R P E
H8-
REV MODE Press REV MODE to select the
reverse mode.
One side will record, and then the
tape will stop automatically at the
tape end.
■:^y. Both sides will record (forward
sid6->reverse side), and then the
tape will stop automatically at the
tape end.
cZ.y- Same as above. (When you press
REC START/STOP, “CX^” will be
automatically switched over to
DECKia
TAPJ
Press TAPE DECK 1/2 to select
“DECK 2”.
r Press < or >, immediately fol-
/r~^ lowed by ■.
i^<\l , ^ ^ ^ This selects which direction the tape runs
T R P E
•• HO.
►: Recording from side A
◄ : Recording onto side B
BAND
..... .
28
(For United Kingdom)
Press TUNER BAND to select
“FM”, “LW” or “MW”.
(For Australia and N.Z.)
Press TUNER BAND to select
“FM” or “AM”.
Press TUNING MODE to select
“PRESET”.
You can aiso seiect the desired broad*
cast station by tuning manuaiiy.
(See page 11.)
8 ^TUNiNG/TiMEADJUST^ Prcss V or A to scIcct the pre-
set channel.
START/STOP
start recording.
To stop recording
Press REC START/STOP again.
Recording can also be stopped by pressing ■.
To cut an unnecessary part while recording
1. Press REC START/STOP when hearing a unnecessary part.
The cassette deck will go Into the stop mode.
2. Press REC START/STOP when wanting resume recording again.
Recording will continue in the same direction as before.
To reduce the noise while MW (AM)/LW
recording (Beat proof function)
Press FM MODE/BP while re­
cording.
Each time you press the button, BP 1, BP 2 and BP 3 will be
displayed alternately.
Select the position where there is less noise.
HD-