Panasonic CF-25 - Manual (Page 29)

Computer Diagnosis
_ „ ____j( ,
List of Error Codes
If a problem occurs with your hardware, and [POST Start up Error(st] is displayed along with
the error code(sj follow the on-screen instructions
Setup Setup Utility (Opage 40) is started Run [Load Default Settings (PnP)j
Next the Setup Utility must be run again to input the appropnate operating environ­
ment settings
Exit Ignore the error message(s) and restart the computer
Code/ " Description, “ - „ .
062 Boot failure—default configuration used Default configuration m use
1 0 1 System Board Failure Interrupt controller failure
1 0 2 System Board Failure Timer 2 lest failure
106 System Board Failure Diskette controller failure
114 Adapter ROM Error Adapter ROM checksum error
151 System Board Failure Real-time clock failure
161 Bad CMOS Battery Dead battery
162 Configuration Change Has Occurred Configuration error
162 Configuration Error CMOS checksum error
163 Dale and Time Incorrect Real-time clock is not updating
164 Memory Si/c Error Memory size error
2 0 1 Memory Size Error Memory size/data error
301 Keyboard Error Keyboard failure
303 Keyboard Error Keyboard controller failure
662 Configuration Change Has Occurred Diskette drive 0 configuration error
762 Configuration Change Has Occurred Coprocessor configuration error
962 Configuration Change Has Occurred Parallel port configuration error
1162 Configuration Change Has Occurred Serial poll configuration error
1762 Configuration Change Has Occurred Fixed disk configuration error
1780 Hard Disk Error Fixed disk 0 failure
1800 PCI Error No more IRQs available
1801 PCI Error No more room for optional ROM
1802 PCI Error No more I/O space available
1803 PCI Error No more memory (above 1 MB) available
1804 PCI Error No more memory (below 1 MB) available
1805 PCI Error Checksum error or 0 size optional ROM
1806 PCI Error PCI-PCI bridge error
1962 I PL Error An operating system could not be found
19990301 I PL Error Hard disk tailure
19990305 I PL Error An operating system could not be found
Using the Self-diagnosis Program
Follow the procedure below to check whether each part of your computer is operating propei ly
y To run the program, insert the Firstaid FD you created into the
floppy disk drive, then turn your computer on
2 When the display below is shown, select [1. Boot]
1 Boot
2 Restore HDD to factory default (For beginners)
3 Restore HDD to factory default (For advanced users)
3 At the MS-DOS prompt (A:\WINDOWS\COMMAND>), input the
following:
diag25 [[Entt.—^1]
Follow the messages on the screen
29