Tuner amplifier section, Timer piay button (□ play), Timer recording button (q rec) – Panasonic SC-CH950 User Manual
Page 16: 0 surround speaker ievel controi (surround), 0 center speaker ievei control (center), 0 volume level controi (volume), 0 input select buttons, Tape, cd, tuner, dat, vcr, vdp, phono), Remote control signal sensor (sensor), Headphones jack (phones)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Front Panel Controls and Functions
(continued)
Tuner amplifier section
0
Power “STANDBY
6
/ON” switch
(POWER, STANDBY Cl)/ON)
This switch switches ON and OFF the secondary circuit power
oniy. The unit is in the "standby" condition when this switch is
set to the STANDBY (!) position. Regardless
of
the switch
setting, the primary circuit is always "live” as long as the
power cord is connected to an electrical outlet.
@ Timer piay button (□ PLAY)
Press to confirm, exit or reset the play timer.
(See pages 64-65.)
@ Timer recording button (Q REC)
Press to confirm, exit or reset the record timer.
(See pages 66-67.)
0
Surround speaker ievel controi (SURROUND)
(Only for model SA-CH950)
Turn to adjust the volume level of the surround speaker.
0
Center speaker ievei control (CENTER)
(Only for model SA-CH950)
Turn to adjust the volume level of the center speaker.
0
Volume level controi (VOLUME)
Turn to adjust the volume level.
Note that — dB is the lowest volume setting and 0 dB is the
highest.
0
input select buttons
(TAPE, CD, TUNER, DAT, VCR, VDP, PHONO)
Press to select the sound source.
@ Remote control signal sensor (SENSOR)
Receives the signals from the remote control.
@) Headphones jack (PHONES)
Plug headphones cord into this jack.
@ Clock/timer button (CLOCK/TIMER)
Press to select the clock set mode or desired timer mode.
@ Timer select buttons (T SELECT A)
Use when setting the current time and timer.
@
Setting button (SET)
Press to set the present time in the clock mode, or set the
various selection in the timer mode. (See pages 25,64-68.)
(3> Preset memory button
(MEMORY, -MANUAL, -AUTO)
Press to put a broadcast station into the memory.
(See pages 27-28.)
@ Band select/allocatlon change button
(BAND, -BAND -ALLOCATION)
Press to select the MW, LW or FM radio band.
Press and hold to change the MW frequency step.
0
Preset tuning buttons (T PRESET
A )
Use to select channel number for a broadcast station which
has been stored in the tuner's memory.
@
Tuning buttons (▼ TUNING A)
Use to tune in a desired broadcast station.