Panasonic KXFLM600NZ - Manual (Page 139)

Important Information
Important Information
( kx - flm 6 ooal only)
Instructions to customer
Installation
Attached to this apparatus is an approval label. This label is evidence that it is a “Permitted Attachmenf which
has been authorized to be connected to your telephone service.
Conditions relating to connection and operation of this Permitted Attachment are contained in
Telecommunications General By-Law 220 (5).
You are authorized to install this Permitted Attachment yourself by plugging it into the line socket of any regular
telephone. You may connect it in place of your existing telephone or to any spare telephone socket installed in
your premises.
To disconnect your existing telephone you must first remove its plug from the line socket. You can then insert
the plug of your Permitted Attachment into the socket and use your equipment.
If the plug of your existing telephone cannot be readily removed, you will have to remove the screw securing it.
To do this proceed as follows:
1. Loosen screw “A" sufficiently to remove the socket cover. (See Fig. 1.)
2. Remove screw “B” and withdraw the plug. (See Fig. 2.)
3. Replace screw “B”. (See Fig. 3.) Ensure that it screws completely into the socket recess. (If the screw is too
long, increase the hole depth or replace the screw with one 5 mm shorter.)
4. Replace socket cover and tighten screw “A”. (See Fig. 4.)
SOCKET PLUG
r 7:^ screw ]
/B"
0
w
Fig. 2
SOCKET
Fig.3 Fig. 4
If you are satisfied with the operation of your telephone service after plugging in your Permitted Attachment,
your installation is completed.
You will be unable to connect this Permitted Attachment if your telephone service consists only of a wall phone
or an old style telephone which is not connected by means of a modern plug and socket. In such cases a new
socket will need to be installed.
Should the Permitted Attachment not operate when plugged into a socket, it is either faulty or unsuitable for
operation with your telephone service. It should be returned to the store where purchased.
Service difficulties
If at any time a fault occurs on your telephone service carry out the following checks before you call for service:
• Disconnect the Permitted Attachment and try using the service with the normal telephone.
• if the telephone service then operates satisfactorily, the fault is in your Permitted Attachment. Leave the
Permitted Attachment disconnected and report the fault to its supplier or agent to arrange for repair.
• If when using the telephone the service is still faulty, report the fault to “Service Difficulties and Faults” for
attention.
You are required to keep this Permitted Attachment in good working order while it is connected to your
telephone sen/ice. Its construction or internal circuit must not be modified in any way without permission.
i ■
; 0‘S
t -t <0
'll
O “
139