Cleaning secondary foam filter, Limpieza del segundo filtro de goma espuma, Replacing hepa exhaust filter – Panasonic QUICKDRAW MC-V7399 User Manual

Page 15: Cambiar del filtro de escape hepa, Lim pieza del segundo filtro de gom a espum a

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Performing the following tasks will keep your new Panasonic vacuum cleaner operating at
peak performance levels and will ensure these high levels for years to come. Check the
BEFORE REQUESTING SERVICE section in this manual for recommendations on performing
some of these tasks to help solve various problems that may occur.

Siguiendo ¡a$ instmcciones dadas, se nueva aspiradora Panasonic funcionará al nivel máximo y
continuará funcionando por mucho años en el futuro. Lea la sección “Antes de pedir serviao” en este

manual para las recomendaciones para arreglar unos problemas que puedan ocurrir.

Cleaning Secondary Foam Filter /

Limpieza del segundo filtro de goma espuma

"k

Secondary

1

Foam Filter

Segundo filtro

The secondary foam filter protects the motor /

El segundo filtro de goma espuma protege el motor

Check filter when Installing a new dust bag /
Ai instalar una nueva bolsa de polvo revise el filtro

>- H dirty, pull filter from bottom of dust

compartment and clean by rinsing in water /

Si esté sudo, tire del fíltro del fondo del

compartimento de polvo y limpíelo enjuagando

con agua

>- When dry, slide filter back into place /

Cuando esté seco deslice el filtro a su lugar

>■ Ensure filter is fully inserted under plastic rib

projections /
Asegúrese de que el filtro está instalado debajo de las lengüetas plásticas

Replacing HEPA Exhaust Filter /

Cambiar del filtro de escape HEPA

HEPA

Exhaust Fitter

and Frame

Filtro de escape

HEPA y el marco

Dust

Cover

Cubierta

de polvo

The HEPA exhaust filter removes dirt from recirculated air /

El filtro de escape HEPA quita el polvo del aire redclado

Check filter when Installing a new dust bag /

Revise el filtro al instalar una nueva bolsa de polvo

>■ If dirty, remove filter from bottom of the dust cover by pulling

straight up on retainers on frame. Lift one side at a time /

Si esté sudo, quite el filtro del fondo de la cubierta de polvo al tirar

hada arriba en las lengüetas del marco. Levante un lado y

después el otro lado

> Place new filter In dust cover DO NOT CLEAN WITH

WATER* /

Coloque el filtro nuevo en la cubierta de polvo No limole

con agua*

>- Place filter In frame and Instali in dust cover, making sure white side is facing up /

Coligue el filtro en el marco y instale la cubierta de polvo asegurando de que el lado danco dé

hada arriba

*Fllter cannot be cleaned and should be replaced at least once each year /

*No se puede limpiar el filtro y se debe cambiarlo a lo menos una vez cada aсo

- 15-

Advertising