Panasonic DMR-T3030 - Manual (Page 12)

■O
S
k. a
V)
O)
,c
Q)
o
STEP 3 Setting the channels and clock
A, V, CH
2.3-4-5
RETURN
Manual Clock Setting
If an error occurs when carrying out Auto Clock Setting, you may
set the time using the following method;
1
Press [SETUP] to show the menus.
Channel
№
I Antenna System n &SrS
I Auto Channel Setting ]
Preset Ctiannel Captionl
Manual Ctiannet CaptlonH
I VCR Plus+ CH Setting |
(t3^{
<tat
2
3
Press [ A , T ] to select “Set Up” and
press [►].
Press [ A , T ] to select “Manual Clock
Setting” and press [ENTER].
Press [ < , ^] to select the item you
want to change and press [ A , ▼] to
change the setting.
MONTH-*---->DAY-i---- »YEAR*---- »HOUR (12-hour display)
I^TIME ZONE*—»DST*-^MINUTE^
DST (Daylight Saving Time): ON or OFF
If you select “ON", the clock is advanced one hour starting
at 2 a.m. on the first Sunday in April and ending at 2 a.m.
on the last Sunday in October.
TIME ZONE:
EST^CST^MST^PST^AST*—»HST
(-5)
(-6) (-7) (-8) (-9) (-10)
t_____________________________________f
5
Press [ENTER].
The “Set Up" screen reappears and the clock starts.
unn
When you change the time zone, the recording times for programs
recorded before the time zone was changed also change to corre­
spond to the new time zone.
Time Zone Adjust
Adjust the time zone (—1 or -FI) if it was not set correctly with auto
clock setting.
You cannot change this setting if you set the clock manually.
1
2
Press [SETUP] to show the menus.
Press [ A , ▼] to select “Set Up” and
press [►].
Press [ A , ▼] to select “Time Zone
Adjust” and press [ENTER].
4 Press [ A , T ] to select “-1”, “0”, or
“+1” and press [ENTER].
The “Set Up" screen reappears.
To return to the previous screen
Press (RETURN].
When you are finished
Press [SETUP],
Adding and deleting channels
While this unit is receiving the antenna signal (but not during
recording):
H
Press the numbered buttons to select
a channel.
Example; “5": [0] [5] Unit's display
“15”: [1]-»[5]
“115”: [100]-^ [1]-F [5]
• You can also use [ a , v , CH]
when you are going to delete a channel.
Press [ADD/DLT].
The channel is deleted if it was set or added if it was not set.
For example
tgÌT?lìmiRiìgifIBD
Repeat steps 1 and 2 as necessary.
HQT6636.