Panasonic DMR-T3030 - Manual (Page 58)

Error messages
On the television Page
No disc. • You haven’t inserted a disc.
Correctly insert a disc that this unit can use.
• The disc is upside down.
If it is a single-sided disc, insert it so the label is facing up.
8
17
This is non-recordable disc.
This disc is not formatted properly.
Please format the disc in ‘DISC SETTING’ to
record.
• The unit cannot record on the disc you inserted. The unit
cannot record onto finalized DVD-R, DVD-Video, CDs, or
video CDs.
Insert a DVD-RAM or unfinalized DVD-R.
• You inserted an unformatted DVD-RAM.
Format the disc with this unit.
8
34
This disc cannot be read. • You inserted an incompatible disc. Insert a compatible disc.
Please check write protect tab on the disc. • The write-protect tab on
the cartridge is set to
PROTECT.
Use a ballpoint pen or
similar to release the
write protection.
Contents of this disc are protected. • The program is write-protected.
Release the protection with the Direct Navigator.
• The disc is write-protected.
Release Disc Protection with DISC SETTING.
36
34
Cannot finish recording completely. • The program was copy-guarded.
• The disc is full.
• Recording was not completed for some other reason.
Cannot record on the disc. • The disc is scratched. Use another disc.
• The disc is dirty.
Please set clock. • The clock is not set. Set the clock. 11,12
0)
u
c
£
0)
cc
This disc may not be played in your region. • You tried to play a disc with a region number different from
this unit’s region number. This unit can only play discs with
the region numbers compatible with this unit (1, All, or includ­
ing the number 1).
Cover page
Your selection exceeds the recorder’s rating limit. • A ratings level has been set for DVD-Video with this unit.
Unlock the unit with “Ratings" in “Disc" in the SETUP menu.
On the unit’s display
51
U11
NO DISC • The disc is dirty or badly scratched.
-Clean the disc if it is dirty.
-The disc cannot be played if it is scratched and this display
doesn't disappear.
• You have inserted a disc the unit cannot play or record on.
Insert a disc the unit can play or record on.
9
8
• The unit is hot.
-The unit switches to standby automatically for safety rea­
sons and you cannot operate it. Wait for about 30 minutes
for the service number to disappear.
-Select a position with good ventilation when installing the
unit.
—
-Do not block the cooling fan on the rear of the unit. —
U99 • The unit fails to operate properly.
Press [cb, DVD POWER] to switch the unit to standby. Now
press [Cb, DVD POWER] again to turn the unit on.
CHK REMOTE • The remote control and main unit are using different codes.
Change the code on the remote control or main unit. 50
RECOVER • A power cut occurred or the AC plug was disconnected while
the power was on.
The unit is carrying out its recovery process. Wait until the
message disappears.
RQT6636