Error messages on the display, General corrective measures, I cannot make and receive calls – Panasonic KX-F560 User Manual
Page 48: I cannot make calls, The unit does not work, Troubleshooting and maintenance, General
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
9. Troubleshooting and Maintenance
Error messages on the display_______________
If the unit detects a problem, one of the following messages will appear on the display.
ERROR MESSAGE
CAUSE AND REMEDY
CHECK COVER
CHECK DOCUMENT
CHECK MEMORY
LIST EMPTY
MECHA ERROR
NO RESPONSE
OUT OF PAPER
PAPER JAMMED
POLLING ERROR
REMOVE DOCUMENT
TRANSMIT ERROR
UNIT OVERHEATED
•The top cover is open. Close it and try again.
•The document is not fed into the unit properly. Re-insert the document
and try again. If misfeeding occurs frequently, clean the feeder rollers
{see page 51). If the problem remains unsolved, adjust the feeder
pressure (see page 51).
• Memory (phone numbers, parameters, etc.) has been erased.
Re-program them.
• No callers’ data is stored in the caller list.
• Mechanical error occurred. Open the top cover and re-install the
recording paper. Then press the STOP button and close the cover.
•The receiving unit was busy or ran out of recording paper. Try again.
•Your unit ran out of recording paper. Install a new roll (see page 6).
•The recording paper is jammed. Clear the jammed paper (see
page 50).
•The other unit does not provide the polling function. Check the other
party.
•The document is jammed. Remove the jammed document (see
page 50).
•Attempted to transmit a document longer than 600 mm (23^"). Press
the STOP button and remove the document (see page 50). Divide it
into two or more sheets and try again.
•Transmission error occurred. Try again.
•The unit is overheated. Leave it as is and allow it to cool down.
General corrective measures
General
I cannot make and receive calls.
—The power cord or telephone line cord is not
connected. Confirm the connection (see page 7).
—The telephone line cord is connected to the
external telephone jack. Connect the cord to the
line jack (see page 7).
I cannot make calls.
—The setting of the dialing mode is wrong. Check
the selector (see page 7).
The unit does not work.
—Disconnect the unit from the telephone line and
connect to a known working phone. If the known
working phone operates properly, call your
service personnel to have the unit repaired. If
the known working phone does not operate
properly, consult your telephone company.
48