STIEBEL ELTRON S-Power PERFORMANCE SERIES Heat Pipe Collectors - Manual (Page 12)

9 8
Install the supporting bracket:
Attach with Locking nut - screw nut M8. +
When installing multiple collectors in series, make sure that the o-ring connector is completely
inserted into both collectors. Collector casing and drum must be mounted straight and
flush with each other.
4 5
Insert the Stiebel Eltron S-Power high performance heatpipe tube into the rubber rings, which have to be
lubricated beforehand with soap.
6
Place the safety rubber ring on top of the glass metal connection. Rotate constantly the s-power high
performance heat-pipe tube while inserting into the hole in the collector casing. Insert the tube so the
safety rubber of the heatpipe tube touches the end of the collector casing and then retrieve the tube out
of the collector casing for 5mm. Stiebel Eltron S-Power high performance heat pipe is now sealed. 7
9
8
12
6 7
4 5
Installation instructions
•
SP-20
•
SP-30
Stiebel Eltron, Inc. 17 West Street West Hatfield, MA 01088
Telephone: 800.582.8423 | Fax: 413.247.3369 | [email protected] | www.stiebel-eltron-usa.com