STIEBEL ELTRON S-Power PERFORMANCE SERIES Heat Pipe Collectors - Manual (Page 5)

Installation Safety
» Always consult local and state building codes and other applicable standards and regulations before begin-
ning a solar collector installation.
» Adhere to all applicable codes and standards during installation. Special consideration must be given to build-
ing code requirements for the penetration of structural members and fire rated assemblies.
» Ensure that the mounting surface to which the collector(s) will be attached are structurally sound and capable
of supporting the load of the collector(s).
» Read and follow all labels/markings on the ladder. Always inspect the ladder prior
to using it. If the ladder is damaged, it must be removed from service and tagged
until repaired or discarded.
» Do not use the top step/rung of a ladder as a step/rung unless it was designed for
that purpose
» Only use ladders and appropriate accessories (ladder levelers, jacks or hooks) for
their designed purposes.
» An extension or straight ladder used to access an elevated surface must extend at
least 3 feet above the point of support (see diagram). Do not stand on the three top
rungs of a straight, single or extension ladder.
» The proper angle for setting up a ladder is to place its base a quarter of the work-
ing length of the ladder from the wall or other vertical surface (see diagram).
» Be sure that all locks on an extension ladder are properly engaged.
» Do not exceed the maximum load rating of a ladder. Be aware of the ladder’s load
rating and of the weight it is supporting, including the weight of any tools or equipment.
» A ladder placed in any location where it can be displaced by other work activities must be secured to prevent
displacement or a barricade must be erected to keep traffic away from the ladder.
3-f
t. min.
x
Distance t
o top suppor
t
x/4
PRODUCT & SAFETY RISKS
This product has been manufactured to provide the highest level of performance and reliability. Nevertheless,
there can still be risks associated with installing, using and maintaining this product.
Dangers can arise from
» Components of the collector become very hot during operation (will burn when touched)
» Other risks may originate from broken glass (cut injury)
» Spurting hot fluid and flowing steam (scalding injury)
» Falling when working on the roof
The Stiebel Eltron S-Power Performance Series HP evacuated-tube solar collector must be installed and put into
operation in accordance with this instruction manual. It must be used exclusively for the described purpose. If used
other than the described purpose (abusive use), dangers for persons can arise and the collector can be damaged.
Misuse of this product can be, for example, filling the collector with other substances than an appropriate heat
transfer medium or the installation on surfaces that are not sufficiently stable.
ALTERATIONS AND CHANGES APART FROM THOSE DESCRIBED IN
THE INSTRUCTION MANUAL ARE NOT ALLOWED.
05