Cradlepoint WIPIPE MBR1000 - Manual (Page 52)

CradlePoint MBR1000 | USER MANUAL Firmware ver. 1.6.9
© 2010 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 50
5.6 MAC Address Filter
Use the MAC (Media Access Control) Address filter sub-menu to control network
access based on the MAC Address of the network adapter. A MAC address is a
unique ID assigned by the manufacturer of a networking device. This feature can
be configured to ALLOW or DENY network/Internet access.
5.6.1 MAC Filtering Setup
Configure MAC Filtering Below. (Default: MAC Filtering Off). When MAC Fil-
tering ON, depending on the mode selected, computers are granted or denied
network access based on their MAC address.
 Turn MAC Filtering ON and ALLOW computers listed to access the
network. When ALLOW is selected; only computers with MAC
addresses listed in the MAC Address List are granted network access.

Turn MAC Filtering ON and DENY computers listed to access the
network. When DENY is selected, any computer with a MAC address
listed in the MAC Address List will not be granted network access.
Filter Wired Clients. When check box is selected, MAC Filtering is applied to
wired clients connected to the MBR1000 in addition to wireless clients.
5.6.2 ADD MAC Filtering Rule
Enable. MAC address entries are activated or deactivated with this check box.
MAC Address. Enter the MAC address of the desired computer or connect to
the router from the desired computer and click Copy Your PC’s MAC Address
button.
Computer Name. Enter the name of the device or computer to which this MAC Address Filter Rule applies.
Save. Record the changes you have made.
Clear. Re-initialize this area of the screen, discarding any changes you have made.
When you are done editing the settings, you must click the Save Settings button at the top of the page to make the changes effective and
permanent.
(continued)