360 Systems DigiCart/E - Manual (Page 31)

File Organization and Navigation • • • • 21
If this message persists, it may be that the DHCP service has not been enabled on the server. It could also
mean that the server is turned off, or there is no connection between the server and the hub to which the
DigiCart is connected.
W AITING FOR NFS
The unit has successfully determined its IP address, either using DHCP or by using a fixed address
assignment. However, if this message persists for more than a few seconds, then the unit was unable to find
a server configured to run the Network File System (NFS) protocol. This service is needed by DigiCart to
access files on the server.
W AITING FOR M OUNT
If this message persists for more than a few seconds, then the current mount path established using the
MOUNT NET DRIVE utility, and saved in the setup file on the DigiCart’s hard disk, could not be found in
the list of exported paths provided by the NFS server.
Either enable NFS sharing on the server for this path, or select a different mount path using the DigiCart’s
MOUNT NET DRIVE utility.
File Navigation User Interface
DigiCart/E employs a 240 x 64 pixel graphics LCD as it’s main display. The display is divided into three
areas. In the upper left area are the command lines that show current machine activity. These two lines
also appear on the RC-series remote controls. The upper right area is used to display context sensitive
navigation clues. The lower area is used to display file lists in the current directory. Using the selection
knob or navigation arrow buttons you can scroll lists.
N AVIGATION C ONTROLS
You can easily move between the Drive/Directory/Files levels by pressing the DRIVES , DIRS or FILES
keys or using the navigation arrow keys. Once a list is selected, use the selection knob to peruse the list.
The current file (or directory or drive) will be displayed in the upper left area of the LCD.
DRIVES Button
Pressing DRIVES activates the drive selection field. The current drive will be highlighted. Use the
selection knob to make a selection.
DIRS Button
Pressing DIRS presents the directory selection list. The current directory will be highlighted. Use the
selection knob to make a selection.
FILES Button
Pressing FILES will display a list of all files in the current directory. The current file will be
highlighted. Use the selection knob to make a selection.