360 Systems DigiCart/E - Manual (Page 69)

Audio Editing • • • • 59
Setting TAIL POINT to a Specific Value
This method allows setting of the Tail point to a known value. This is accomplished without playing the
audio.
Select a cut and press EDIT . Select TAIL by using selection knob. Press ENTER . The current Tail
point will be indicated on the display.
Use the selection knob and navigation arrows to adjust the Tail position value. The current field is
shown on the display in brackets:
<H> = Hours, <M> = Minutes, <S> = Seconds, <F> = Frames or <B> = Bits.
Press PLAY to audition the new Tail point. Repeat the previous steps as needed to adjust the Tail point
position.
Press ENTER to save the new Tail point, or EXIT to close the cut with no change.
Setting the TAIL POINT using Auto-Set
The Auto-Set feature allows setting the Tail point during audition. In Edit mode, use the PLAY button to
start playback and the STOP button to set the Tail point location and stop playback.
Select a cut and press EDIT. Select TAIL by using the selection knob. Press PLAY and the cut will
begin playing from the Head point. The display will begin counting from 00:00:00:00.00, which
represents time from the current Head point. Press
STOP to set the new TAIL point location.
After pressing the STOP button, the display will show the previous TAIL point on the top line and the
newly selected TAIL point on the next line. You may use the selection knob and navigation arrows to
adjust the TAIL position value.
Press PLAY to audition the new TAIL point. DigiCart/E will begin playback of the cut according to
the current Pre-Roll setting. Repeat the previous steps as needed to adjust the Tail point position.
Press ENTER to save the new TAIL point, or EXIT to close the cut with no change.
P RE -R OLL
Enables you to set the time ahead of the TAIL or FADE OUT point for auditioning during edits.
Depending upon the nature of the cut, or its total length, you may want to vary the length of the PRE-
ROLL. If the PRE-ROLL length exceeds the duration of the cut, it will be ignored and the entire cut will
play.
Press the EDIT button. Select PRE-ROLL by using selection knob. Press ENTER to edit the value.
You may use the selection knob and the navigation arrows to adjust the PRE-ROLL value.
Press ENTER to save or EXIT to abandon the PRE-ROLL setting without changes.
F ADE I N
After you have recorded a cut, you can program a FADE IN. FADE IN is linear and always begins at the
HEAD point of a cut, and cannot exceed total cut length or the amount of time between the HEAD point
and the beginning of a FADE OUT. The maximum FADE length is 40 seconds.
When adjusting FADE IN duration, time is measured as the number of seconds from the HEAD point to the
end of the fade. A value of 00:00:00:00:00 equals no Fade In.
NOTE: If you use PAUSE during the FADE IN period of the cut’s playback, when PAUSE is released the
FADE IN will start over from silence.