Aviom AV-M8 - Manual (Page 20)

12 Av-M8 M
ic
i
nput
M
odule
u
ser
G
uide
computer outlets. Cables can be extended by using a simple passive device
called an inline coupler to add length to existing cables (as long as you do not
exceed the specified maximum cable length). If you need a longer cable on
occasion, this is a simple solution. Note that it is possible that the maximum
cable length specification can be compromised by using inline couplers or
other passive connection devices.
AC Line Conditioning
Aviom products are digital devices and as such are sensitive to sudden spikes
and drops in the AC line voltage. Changes in the line voltage from lightning,
power outages, etc. can sometimes damage electronic equipment.
To minimize the chance of damage to your equipment from sudden changes
in the AC line voltage, you may want to plug your equipment into a power
source that has surge and spike protection. Power outlet strips are available
with built‑in surge protection circuits that may help protect your equipment.
Other options for protection of your equipment include the use of an AC
line conditioner or a battery backup system (sometimes referred to as an
uninterruptible power supply, or UPS).
Power Supplies
The power supply in your Aviom product is a universal switching type. It is
capable of working with voltages from 90 to 240 volts AC. This means that a
separate power supply is not needed to use the products with the AC power
systems found in most countries. You should always use the IEC power cable
that shipped with your product.
Mounting the AV-M8
The AV‑M8 Mic Input Module is designed to be surface mounted to the
underside of a tabletop or similar flat surface. It can also be installed in a
standard 19‑inch audio equipment rack, using the optional rack‑mount ears.
Rack ears can be attached to the front or rear of the AV‑M8. Each AV‑M8 unit
takes up one standard rack space (19 inches wide by 1.75 inches high).
The mounting flanges as well as the rack ears are designed to support the
weight of the AV‑M8 without additional hardware. The mounting flanges can
be reversed easily using a Phillips head screwdriver. Each mount contains
holes for two screws per side. Always support the unit with all four screws.