Aviom AV-M8 User Manual
Page 43
35
Av-M8 M
ic
i
nput
M
odule
u
ser
G
uide
Pro16 Output
Channels 1-16 In
Channels 1-16 Out
Channels 17-32 In
Channels 17-32 Out
A-Net
A-Net Expansion
Audio channels 17-32
Audio channels 1-16
Pro16 Output
Pro16 Input
Pro16 Input
Two Pro16 input modules configured as 32 x 0
Two Pro16 output devices are connected on the receive side of the audio
network. In the diagram, any Pro16 output device can be used. This includes
A‑16II and A‑16R Personal Mixers, as well as AN‑16/o and AV‑P2 Output
Modules.
To configure a 32 x 0 system:
Connect the first 16 mic or line‑level audio sources to
1.
inputs 1‑16 on the first Pro16 input module.
Connect the second group of 16 audio sources to inputs
2.
1‑16 on the second input module.
Connect a Cat‑5e cable from the
3.
a-N
et
o
ut
port on the first
input module to the a-N
et
e
xpaNSIoN
port on the second
input module.
Connect a cable from the
4.
a-N
et
o
ut
port on the second
Pro16 Series input module and run it to the destination
where the Pro16 output modules are located, and plug it
into the a-N
et
I
N
port on the first output module.
Connect a Cat‑5e cable from the
5.
a-N
et
e
xpaNSIoN
port on
the first output module to a-N
et
I
N
on the second output
module.
Patch the audio outputs from the two output modules into
6.
the desired destinations.
Remember that the maximum cable length between A‑Net devices is 500
feet (150 meters). Always use Cat‑5e UTP cable.
The diagram that follows shows two pair of 16‑channel AV‑M8 units
configured as primary/secondary using the ADAT optical link.