Checkline FGS-220VC - Manual (Page 12)

- 7 -
5.2. Operation mode
The operation mode consists of manual and program.
The mode is selected by the measurement purpose and the usage.
How to select the mode?
Pressing MODE switch in the Operation panel, the mode changes one by one as follows.
A present operational mode is displayed under the left of LCD.
You wish to test by PUSH or PULL key.
e.g.,
 You want to move to the position of PULL limit by
pressing PULL switch.
 You want to move only while you press the
PUSH key.
 You want to move the round trip operation many
times between limits of PUSH and PULL.
etc.
Select manual operation modes :
MANU, JOG, SING, CONT..
You wish to move complex operations.
e.g.,
 You want to measure by specifying the positions.
 The position of the object to be measured
cannot be specified.
 You want to combine a different direction
(PUSH/PULL) of operation with a test.
etc.
Select Program operation mode.
MANU
mode
MODE
Parameter
setting mode
JOG
mode
MODE
SING
mode
MODE
PROG
mode
MODE
CONT
mode
MODE MODE