Checkline FGS-220VC - Manual (Page 24)

- 19 -
Parameter
The parameters are available while stopping.
Pressing SET button, the parameter setting starts.
The contents of the parameters setting is shown in the below flowchart.
Finally press SET button for saving.
If you want to cancel the setting, press ZERO button.
Condition setting
Force limit
The PUSH or PULL button can
be used to change.
The sign of force limit is changed
by MAX button alternately.
Repeat times
The UP or DOWN button of the
SPEED can be used to change.
The maximum value is 9999.
When the display is o and press
DOWN it will be 9999, and when
the display is 9999 and press UP
it will be 0.
SET
SET
Next page
Moving direction
The parameter is the
direction of movement
from
“Start point” to
“Detect point”.
The STOP button can
be changed to Push or
Pull alternately.
Detect object
The force for detecting
object can be set by
PUSH or PULL button.
Speed
The parameter is the speed
setting for moving from "Start
point" to "Detect point".
The UP or DOWN button of the
SPEED can be used to change.
SET
SET
Zero force
After detecting the
object, the stand moves
to opposite direction until
sensing the force less
than the setting force
data.
The PUSH or PULL
button can be used to
change.
Speed
The parameter is the speed
setting for moving from "Detect
point" to "Standard point".
The UP or DOWN button of the
SPEED can be changed.
Dwell timer
The parameter is the dwell timer
at "Standard point".
Pressing STOP, the dwell timer is
incremental.
When the dwell timer is 5s, it
returns to 0s pressing STOP.