Freerider FR168-4A(Ascot-4,12Ah) - Manual (Page 14)

26 27
● Chassis for sound welds
● Rear Drive wheel hub key
● All wheel bolts
● Drive axle securing nuts
● Motor mounting bolts
● Magnetic motor brake disc and function
● Main wiring loom for damage
● All steering components
● Clean chassis and repaint any exposed parts
● Lubricate on/off power key barrel with
● Replace any damaged axle seals
● Cycle test charger for full operation function
● Cycle test batteries for operating capacity (This test
can be performed by your Freerider Agent)
NOTE: The items listed under the weekly and six
months inspection should be incorporated into this
annual inspection.
LUBRICATION
Use a general purpose light lubricating oil on moving
parts. All wheel bearings are factory sealed and should
not normally need lubricating. Handle bar bearings
should be lubricated with a general purpose bearing
grease.
Your drive axle is factory filled with a special lubricant
and will not normally need replacing.
Caution: Do not mix other lubricants with this
factory fitted drive axle lubricant. Failure to observe this
caution will invalidate your guarantee.
Please note: These service intervals are a guide, more
frequent use of your Scooter may require adjustment to
these suggested intervals.
RECOMMENDED AREAS FOR ADJUSTMENT
STEERING COLUMN ADJUSTMENT
The steering column locking system works on a 'cam'
principle to lock the column in the de sired driving
position (see Fig 7 page 8).
If you notice the column is not firmly held when the
black cam operating lever is fully down, follow this
procedure to readjust the 'cam' tension:
1. Push steering column forward as far as it will go with
the locking l ever released, ie. pushed upwards. Support
steering column.
2. With a 10mm spanner (not supplied) loosen the
locking nut positioned on the opposite side to the black
locking lever. (Fig. 32)
3. Next to the locking nut is a chrome threaded 'clamping
nut' this has a slightly tape red shape. Turn this
clamping nut clockwise approximately a quarter of a
turn.
4. Push the 'black' clamping lever down and test that
the tiller is tightly held in place; adjust 'clamp nut' until
correct tension is achieved on clamp plates.
5. Tighten locknut with 10mm spanner.
TECHNICAL SPECIFICATION
168-3A3 SPECIFICATIONS
Overal length
94 cm/37 inches
Overal width 51 cm/20 inches
Ground clearance 8.5 cm/3.4 inches
Maximum load 114 kgs/250 lbs
Range up to 16 km/10 ml
Total weight (excl. batteries) 32.5 kgs/78 lbs
Heaviest part 12 kgs/26 lbs
Wall to wall turning radius 81 cm/32 inches
Maximum Speed 6 km/ 4 mph
Battery 12 Amp
168-4A SPECIFICATIONS
Overal length
99 cm/39 inches
Overal width 51 cm/20 inches
Ground clearance 8.5 cm/3.4 inches
Maximum load 114 kgs/250 lbs
Range up to 16 km/10 ml
Total weight (excl. batteries) 39 kgs/85 lbs
Heaviest part 14 kgs/31 lbs
Wall to wall turning radius 116 cm/45.5 inches
Maximum Speed 6 km/ 4 mph
Battery 12 Amp
FIG 29