Freerider FR168-4A(Ascot-4,12Ah) User Manual
Page 6
10
11
smooth level road surfaces. It climbs slopes safely up
to 8° and over obstacles up to 2.5cm (1”). Your Scooter
should not be used in torrential rain or snow, on loose
slippery surfaces and slopes or on wet grass etc., which
could become a danger to the rider, and the scooter.
Passengers must not be carried. Excess baggage
outside of the seating area can affect stability.
Your FR 168-3A3/4A is a ‘Class 2’ (B)* vehicle and
designed for pavement use only. The FR 168-3A3/4A
must only be used on the road with caution if a
pavement is not available. It is designed for a single
occupant who experience difficulty or discomfort
when walking for prolonged periods, but has the use
of both legs and the physical, visual and cognitive
ability to operate the Scooter safely.
Do not drive your FR 168-3A3/4A if you are under
the influence of alcohol, drugs or medication that may
affect your ability. If in doubt consult your doctor.
As a pavement user you should familiarize yourself
with the current legislation contained within the
Highway Code.
* Definition
Electrically powered scooters are classified in the
following categories:
Class 2 as defined in “The Use of Invalid Carriages on
the Highway Regulations 1988”. A Scooter type invalid
carriage designed for the use on the footway, with
maximum speed up to 4mph.
Class ‘B’ as defined in The European Standard
EN12184: 1999. A scooter sufficiently compact
and maneuverable for some indoor environments
and capable of traveling over longer distances and
negotiating outdoor obstacles.
GETTING TO KNOW YOUR FR 168-3A3/4A
Your FR 168-3A3/4A Scooter is delivered in a strong
tri-wall carton. When unpacking the carton, first
remove all of the sharp metal staples which are located
in the top. Carefully dispose of the staples to avoid
injury. Remove all packing materials, avoid using sharp
instruments as this may damage the Scooter. Carefully
remove the Scooter from the carton; to minimize
damage to the Scooter and the operator, two people
should be used for this operation.
Safely dispose of all packaging materials, your local
waste disposal authority can advise you on this
procedure.
Your FR 168-3A3/4A Scooter is delivered fully
assembled, fitting the two batteries, driving mirror and
the seat assembly together with minor adjustments are
detailed on the following pages under ‘Operating your
FR 168-3A3/4A . A full technical specification for
your FR 168-3A3/4A can be found at the rear of this
manual.
A great deal of thought and consultation has gone
into the design of your state-of-the-art, life-changing
Scooter. Your FR 168-3A3/4A Scooter will help to
increase your mobility and therefore give you more time
and energy to enjoy life.
The FR 168-3A3/4A is a medium size three wheeled/
four wheeled vehicle which will allow you to negotiate
obstacles found in confined shopping areas. This
is just one of the features you will find on your FR
168-3A3/4A scooter. Others are:
COMFORT -
The contoured seat helps cushion you
from the vibrations of a journey, giving you maximum
comfort. A fully proportional speed-controller with a
speed restriction facility allows you a smooth, safe jerk-
free ride. Automatic braking system gives system you
that added peace of mind.
VERSATILITY -
The removable fold down seat,
together with a facility to fully lower the steering
handlebar, allows your FR 168-3A3/4A to be easily
transported in an average saloon or hatchback car for
those days when you travel further afield.
SERVICE -
Your Freerider FR 168-3A3/4A has
been designed to be service friendly. Sealed batteries
which are virtually maintenance-free will give your FR
168-3A3/4A the power it requires. Should you need
to take your batteries on an aircraft, then you can have
peace of mind because the batteries are totally spill-free.
(Please consult your carrier for details).
SAFETY -
The advanced speed controller has been
designed with extensive self-checking circuits to give
you the maximum ‘state-of-the-art’ safety technology.
Fully automatic braking system gives the driver
confidence in any environment. The on/off key can be
removed for added security and safety, this disables the
electronic drive circuitry, and your FR 168-3A3/4A
cannot therefore be driven away by any other person.
CAUTION -
Do not switch ‘off ’ the on/off power key
when you are moving; this will automatically apply the
motor parking brake suddenly and could place you in
a dangerous situation. Your FR 168-3A3/4A is fitted
with anti-tipping wheels. Do not remove these anti-
tipping wheels, they are an important part of the FR
168-3A3/4A provided specifically for your safety. They
help protect against backwards tipping on excessively
sharp inclines
CHARGING -
Your FR 168-3A3/4A is fitted with
a battery level indicator. Charging is straight forward.
Your charger is fully automatic and will reduce to a top-
up charge mode when the re-charge cycle is complete.
(See Batteries and Battery Charging section of this
manual).
FREEWHEELING YOUR SCOOTER
If for reasons of convenience, you require to push your
FR 168-3A3/4A Scooter for a short distance, the drive
system can be put into ‘freewheel mode’. This will allow
your FR 168-3A3/4A to roll freely.
FR 168-3A3/4A FREEWHEEL PROCEDURE
The freewheel device is a red lever located at the top,
rear right hand side of your Scooter (Fig 1). Access is
available from under your seat. To freewheel your FR
168-3A3/4A first switch off the power switch located
on the FR 168-3A3/4A’s control console (Fig 7). Pull
forward the red lever (Fig 1) until a distinct click is felt
(disengage). You can now push your FR 168-3A3/4A
with ease. Please note, in this mode with the power
switch in the off position, the braking safety system
is automatically activated when the Scooter is pushed
quicker than walking speed.
By switching on the console power switch at this
stage you will introduce some heavy motor braking,
you will note the green status light on your console is
now flashing five times. This indicates that your FR
168-3A3/4A is in a freewheel mode and you cannot
drive your Scooter. Note, the quicker you push your
Scooter the heavier the brake will be applied.
To re-engage the drive system, simply push backwards
on the red handled lever until a distinct click is felt.
Switch the power switch on your console off and then
on, the green status light will be fully illuminated and
you will be able to drive your FR 168-3A3/4A once
again.
Warning:
Do not sit on your FR 168-3A3/4A
Scooter with the freewheel device in the disengage
position. Your FR 168-3A3/4A Scooter has limited
braking and will not drive in this mode, the green
status light on your console will flash five times.
Warning:
If your FR 168-3A3/4A Scooter is in
the freewheel mode when you turn on your power
key switch and depress your speed forward - reverse
lever, you will not be able to move under motor power.
Dismount and re-engage the drive system by pulling
DISENGAGE
ENGAGE
BRAKE
FIG 1
backwards on the red handled lever (engage). Remount
your Scooter, switch the power switch off and on again
until the green status light fully illuminated. Your FR
168-3A3/4A will now drive under motor power again.
Warning:
Always check that the freewheel device
is in the drive position before attempting to drive your
Scooter after it has been left unattended for a period of
time. Failure to observe this warning may result in an
accident.
General note: If you are able to push your Freerider FR
168-3A3/4A the drive system is disconnected. Do not
attempt to drive your Scooter. Please check once again
the above mentioned procedure for re-engaging the
drive.
Warning:
If your batteries are disconnected from
your Scooter there will be no brake function in the
freewheel mode. Do not leave your Scooter unattended
in this situation as it could roll away causing damage to
other parties or property. Always re-engage the drive
system when left unattended.
Warning:
Yellow warning notice label situated on
your rear cover located under your seat.
Please take extreme care
LEARNING TO GET ABOUT
Warning:
If you are not an accomplished outdoors
mobility product driver, we strongly recommend that
you first practice in an open area, free from traffic and
preferably with an attendant who can assist you.
MOUNTING
For your first drive make certain that you and your new
FR 168-3A3/4A Scooter are on a level surface. Put
the power on/off key into its slot, but leave it turned
off. Stand behind the FR 168-3A3/4A’s seat, and reach
down to the ‘Seat Lock Lever’. It will be on the left
side directly under the armrest. Grasp the ‘black’ knob
on the lever and pull up, releasing the Seat (Fig 10). It
will now turn easily to meet you. If need be, you can
lock the seat into position to make it steady before you
sit down. You can also lift up the armrest to assist this
procedure. Seat yourself and swing the seat to face the
handlebars. Make sure you are straight, then release the
spring assisted lever, making certain that it locks your
seat firmly in position.
Next, turn the ‘Speed Adjustment Dial’ to minimum
(min), and turn the ‘on/off ’ key to ‘on’ (Fig 8, page 9).
WARNING
EMERGENCY FREEWHEEL DEVICE
NEVER SIT ON YOUR SCOOTER WITH THE
FREEWHEEL DEVICE IN THE DISENGAGED
POSITION. ALWAYS RE-ENGAGE THE
EMERGENCT FREEWHEEL DEVICE AFTER
USE. FAILURE TO COMPLY WITH THIS
WARNING MAY RESULT IN INJURY.