FRITSCH PULVERISETTE 0 - Manual (Page 4)

Table of contents
1 Basic structure............................................................................... 7
2 Safety information and use........................................................... 8
2.1 Requirements for the user..................................................... 8
2.2 Scope of application............................................................... 8
2.2.1 Operating principle............................................................. 9
2.2.2 Amplitude control............................................................... 9
2.3 Obligations of the operator................................................... 9
2.4 Information on hazards and symbols used in this manual. . 10
2.5 Device safety information.................................................... 13
2.6 Protective equipment.......................................................... 14
2.7 Hazardous points................................................................. 14
2.8 Electrical safety.................................................................... 14
2.8.1 General information......................................................... 14
2.8.2 Protection against restart................................................. 14
2.8.3 Overload protection.......................................................... 15
3 Technical data.............................................................................. 16
3.1 Dimensions.......................................................................... 16
3.2 Weight.................................................................................. 16
3.3 Operating noise.................................................................... 16
3.4 Voltage................................................................................. 16
3.5 Current consumption........................................................... 16
3.6 Power consumption............................................................. 16
3.7 Electrical fuses..................................................................... 17
3.8 Load..................................................................................... 17
3.9 Material................................................................................ 17
3.10 Final fineness of a grinding process with the PULVERI-
SETTE 0............................................................................... 17
4 Installation................................................................................... 18
4.1 Transport............................................................................. 18
4.2 Unpacking............................................................................ 18
4.3 Setting up............................................................................. 18
4.4 Ambient conditions.............................................................. 19
4.5 Electrical connection............................................................ 19
4.5.1 Adjusting the mains voltage.............................................. 20
5 Initial start-up.............................................................................. 21
5.1 Switching on......................................................................... 21
5.2 Function check..................................................................... 21
5.3 Switching off........................................................................ 21
6 Using the device........................................................................... 22
6.1 Conducting a grinding operation......................................... 22
Table of contents
- 4 -