FRITSCH PULVERISETTE 25 - Manual (Page 26)

page 25
PULVERISETTE 25
9. Pull the funnel cable out of the angled screw coupling by
sliding the clamping ring down and pulling the black cable
guide out of the angle coupling.
10.Unscrew the angled screw coupling from the motor cover and
close the hole with a cap. Screw this in with a screwdriver.
11.Position the motor cover (14) and screw it on.
12.Use an Allen key to unscrew the four M6x12 cheese head
screws with which the standard funnel (1) is fastened to the
upper housing (2) and lift off the standard funnel (1).
13.Insert the protected funnel (22) and fasten it with the four
M6x12 cheese head screws and the washers.
14.Reconnect the cutting mill to the mains.
15.The instrument is ready for operation.