FRITSCH PULVERISETTE 13 premium line - Manual (Page 15)

2.8.2 Protection against restart
The device shuts down if there is a power outage.
n The mill comes to a standstill within seconds.
n Grinding stock container can only be opened by an emergency
release (k) on the inside of the device. For that, the housing cover
(14) needs to be removed as follows. (See also Ä Chapter 4.3 ‘Set‐
ting up’ on page 18).
– Open the housing cover (14) by releasing the quick release
screws attached on both sides.
– Once the quick release screws are loosened, pull the housing
cover (14) back a few centimetres and then lift it off.
n The emergency release (k) on the inside of the device can then be
seen.
n To release the grinding stock container, pull the emergency release
(k) backwards until the lock pin (9) of the grinding stock container
(10) is released.
Quite a bit of effort is needed for the release.
n Afterwards, the emergency release can be simply snapped back in
and the housing cover closed. At the next start of a grinding, the
grinding stock container is drawn in as usual.
NOTICE!
The grinding chamber cannot be opened when the grinding
chamber lock is closed and the device is switched off.
When electrical power returns, the disk mill does not start up by itself.
n The mill is secured against restarting.
n The motor is restarted by pressing the Start button (e) and the mill
begins working.
Safety information and use
- 15 -