FRITSCH PULVERISETTE 13 premium line - Manual (Page 40)

NOTICE!
Hold the grinding disks firmly during the exchange and do
not drop them. This can cause disks made of zirconium
oxide to break or splinter.
Tools needed:
n Size 30 socket with locking handle (T and K)
n Locking spanner (B)
n M30 spanner (R)
n Hexagon socket set (I)
DANGER!
Make sure that the mains plug is disconnected from the
mains after step 6.
1. Connect the device to the mains.
2. Switch main switch (3) to I (ON).
3.
To ensure better access to the hexagon screws on the
back of the movable grinding disk, the grinding gap
should be adjusted to the smallest width. (See
Ä Chapter 6.4 ‘Setting the gap width’ on page 27).
4. Afterwards, press the release button (h) on the control panel.
Maintenance
- 40 -