Inovonics Radius Installer - Manual (Page 31)

6.24.13 06325C © Inovonics, 2013 - www.inovonics.com 30
Chapter 8
Pager Installation and Configuration
8.1 WaveWare Paging Base Installation
The WaveWare paging base is a 5 watt paging base station programmed for
469.6500 MHz POCSAG compliant pagers.
To install the WaveWare paging base:
1 Mount the paging base.
• Generally, it’s best to mount the paging base in an elevated position,
away from metal.
• The paging base is shipped with a six foot serial cable. However, the base
station can be mounted up to 20 feet from the Radius server if needed.
2 Attach the supplied antenna to the paging base.
Caution: Do not test the paging base without the antenna attached. Doing so can harm
the paging base.
3 Plug the paging base’s serial cable into COM 2 on the Radius server.
• The COM port settings for the Radius process creation are 9600/8/1/N.
The port settings are set by default.
8.1.1 Configure the Paging Base
1 Access the Radius interface and log in.
2 Click “Install Setup.”
3 Click “Process Setup.”