Canon IR3300 - Manual (Page 40)

Settings Menu 3-8
3
Pr
inter Settings Men
u Functions and Oper
ation
Margin -30.0 - 0.0 - +30.0 mm (in increments of 0.5 mm)
This setting sets the page margin in mm. The settings can be set between
-30.0 mm (-1.20 inch) to +30.0 mm (+1.20 inch) in increments of 0.5 mm
(0.01 inch).
Use [ ] to increase the width of the inside margin. Use [ ] to
increase the size of the outside margin.
You can specify the edge along which the margin will be created in the
Binding setting (previous setting.) To create a margin along one of the
edges of the paper, use this setting in combination with the Binding setting.
IMPORTANT
• If this setting moves the image outside the printable area,
part of the image may be cut off.
NOTE
• If this setting is used in combination with the Offset X/
Offset Y setting, the two settings are added together.
• Pressing [ ] increases the setting value by 0.5 mm
(0.01 inch) each time the key is pressed. Pressing [ ]
decreases the value by 0.5 mm (0.01 inch) each time.
Holding down either [
] or [ ] continuously speeds
up the value alteration.
[ + ] [ - ] [0mm]
Left Margin
Center Center Center
Right Margin
iR33/28/22RG.book Page 8 Thursday, May 10, 2001 5:27 PM