Canon IR3300 - Manual (Page 67)

Printing Problems 5-7
T
roub
leshooting
5
The data does not fit on the page properly (All of the data that should be on the
page is not printed)
The printing location has slipped
Data that should be printed on the same page is printed on two separate pages
Cause 1
The paper is not in the correct position.
Solution Make sure the printer’s set correctly and try printing again.
Reference
See “Loading Paper,” in the Reference Guide.
Cause 2 A full page of data, without a border, was printed.
Solution
Insert a border greater than 5 mm (3/16 in.) around the data and print the data again.
(Data cannot be printed in a border area of 5 mm (3/16 in.) around the data.)
Reference See the application software manual.
Cause 1 Margin, Offset X or Offset Y in the printer settings menu have been changed.
Solution
Set Margin, Offset X and Offset Y to 0.0 and print the data again.
Reference See “Margin,” on p. 3-8.
See “Offset X,” and “Offset Y,” on p. 3-10.
Cause 2
The application software’s top margin and paper location settings are not correct.
Solution Set the correct settings for the top margin and the paper location and print the data
again.
Reference
See the application software manual.
Cause 1
The application software’s “Line spacing” and “Number of lines on a page” settings are
not correct.
Solution Change the settings so that the data fits on one page and print the data again.
Reference
See the application software manual.
Cause 2 The Timeout setting is too short, when the Personality setting is set to Auto.
Solution
Change the Personality setting to a setting other than Auto, or the increase the Timeout
setting.
Reference See “Personality,” on p. 3-19.
See “Timeout,” on p. 3-12.
iR33/28/22RG.book Page 7 Thursday, May 10, 2001 5:27 PM