Canon IR3300 - Manual (Page 42)

Settings Menu 3-10
3
Pr
inter Settings Men
u Functions and Oper
ation
Offset X
Offset Y -50.0 - 0.0 - +50.0 mm (in increments of 0.5 mm)
This setting sets the offset position in mm. The settings can be set
between -50.0 mm (-2.00 inch) to +50.0 mm (+2.00 inch) in increments of
0.5 mm (0.01 inch).
The print position is adjusted in the vertical or horizontal direction only to
the value specified in the setting value.
You can increase or decrease the setting in increments of 0.5 mm (0.01
inch) to adjust the print position as described below.
Offset X: Increasing the setting value moves the image in the X
direction on the paper. Decreasing the setting value moves
the image in the X direction on the paper.
Offset Y: Increasing the setting value moves the image in the Y
direction on the paper. Decreasing the setting value moves
the image in the Y direction on the paper.
IMPORTANT
• Please note that if the print position is adjusted to place
print data outside the valid print area, the portion outside
the valid print area will not be printed.
NOTE
• Pressing [ ] increases the setting value by 0.5 mm
(0.01 inch) each time the key is pressed. Pressing [ ]
decreases the value by 0.5 mm (0.01 inch) each time.
Holding down either [
] or [ ] continuously speeds
up the value alteration.
DEF ABC
ABC DEF
X X
Y Y
Adjust using
X/Y-Adjustment
Area adjusted using Y-Adjustment
[+]
Area adjusted using
X-Adjustment
[+]
iR33/28/22RG.book Page 10 Thursday, May 10, 2001 5:27 PM