Auto hold – BMW 2013 5 Series User Manual

Page 67

Advertising
background image

Pull the switch and hold it. The vehicle brakes
hard while the button is being pulled.

The indicator lamp lights up red, a signal
sounds and the brake lamps light up.
Lower lamp: indicator lamp in Canadian
models.

If the vehicle is braked to a speed of approx.
2 mph/3 km/h, the parking brake remains set.

Releasing

With the ignition switched on:

Manual transmission: Press the switch
while the brake or clutch is pressed.

Automatic transmission: Press the switch while
the brake is pressed or transmission position P
is engaged.
The LED and indicator lamp go out.

The parking brake is released.

Automatic Release in cars with

automatic transmission

For automatic release, operate the accelerator
pedal.
The LED and indicator lamp go out.
Subject to the following requirements, the park‐
ing brake is automatically released by operation
of the accelerator pedal:

Engine on.

Drive position engaged.

Driver buckled in and doors closed.

Inadvertent operation of the accelerator
pedal

Make sure that the accelerator pedal is not op‐
erated unintentionally; otherwise, the vehicle is
set in motion and there is a risk of an accident.◀

Automatic Hold

The concept

This system assists the driver by automatically
setting and releasing the brake, such as when
moving in stop-and-go traffic.
The vehicle is automatically held in place when
it is stationary.
On inclines, the system prevents the vehicle
from rolling backward when driving away.

For your safety

Under the following conditions, Automatic Hold
is automatically deactivated and the parking
brake is set:

The engine is switched off.

A door is opened and driver's safety belt is
unbuckled while the vehicle is stationary.

The moving vehicle is brought to a standstill
using the parking brake.

The indicator lamp switches from green
to red and the letters AUTO H go out.
Lower lamp: indicator lamp in Canadian
models.

Leaving the vehicle with the engine run‐
ning

Before leaving the vehicle with the engine run‐
ning, engage position P of the automatic trans‐
mission and ensure that the parking brake is set.
Otherwise, the vehicle may begin to roll.◀

Seite 67

Driving

Controls

67

Online Edition for Part no. 01 40 2 903 008 - 07 12 490

Advertising