Touch start, Adding pause to the cycle in operation, Pause between (cook) cycie and probe temp – Whirlpool SM988PES User Manual

Page 31: Using pause with auto sensor

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

6. TUrn over or rearrange

food being defrosted.
Close door.
NOTE: Oven will

remain off until you

touch START.

7.

Touch START.

I~

_

_f

/_ /

I U

The QUICK DEFROST Indi­
cator stays on and the
Display counts down the

remaining time.

When the defrost time
ends, “End" will show on
the Display and 4 beeps
will sound. (You can stop
the beeping by opening
the door or by touching
CANCEL) "End" will remain
on the Display and a beep |
will sound every 30 sec­
onds (to remind you that
food is in the oven) until
door is opened or CANCEL
is touched. The Display will
then show the time of day.

Adding PAUSE to the cycle in operation

Pause oan be added to any cycle in operation as long as there is another
cycle programmed to follow. It can also be added to QUICK DEFROST or AUTO
SENSOR after START has been touched.

1. Touch PAUSE.

2.

Touch START.

The oven will automatically stop after the cycle in operation to allow you to
stir, turn, or rotate food or add additional ingredients. It will stop halfway
through QUICK DEFROST to allow you to turn over or rearrange the food being
defrosted. It will stop after the first (AS) part of the AUTO SENSOR oyole to allow
you to stir, rotate or rearrange food orto add ingredients. NOTE: The oven will

remain off until you touch START.

PAUSE between (COOK) cycie and PROBE TEMP

PAUSE is automatic between COOK 1 or COOK 2 and PROBE TEMP “PROB"
will show on the Display to remind you to plug in the probe. Touch START to
continue cooking.

Using PAUSE with AUTO SENSOR

PAUSE may be used in AUTO SENSOR with the Cook/Reheat or Cook Frozen
cycles only.

continued on next page.

31

Advertising