Chamberlain SL 1000-X3 - Manual (Page 11)

Rev J Doc 01-20098 Page 11 of 44
2. Installing Chain and Anchors (Front Drive Gate Installation)
Figure 10-A. Anchor and Chain Connector.
Figure 10-B. Parallel Chain Location
1. Weld the Gate Anchors to the edges of the gate as shown in Figure 10-B.
2. Using master link, secure chain to the chain connector on one of the chain anchors. (Fig.
10-A).
3. Route chain through gate operator to the opposite Gate Anchor and secure chain to the
chain connector using master link.
4. Ensure the chain is parallel to gate travel both horizontally and vertically.
5. Use the jam nut on the chain connector to secure the chain and adjust for proper tension.
NOTE: For rear and mid drive installations, see Figures 2 and 3.