Kenmore 808353 - Manual (Page 15)

WAT ER SUPPLY
Plumbing musi comply with local codes It is recommended that a shut-off valve be installed m the line from the
supply to the dishwasher The water supply must be able to supply a minimum of 9 quarts in one minute Route the
line, as shown in Figure 7 (Refer to Figure 5 for permissible routing areasi Do not run it across in front of the motor
Piping must not be kinked The connection to the valve is made with a 3/8" male pipe thread right angle adapter
Assemble the adapter to the valve, using pipe compound or teflon tape, with a wrench on the adapter and a wrench
over the metal bracket enclosing the fitting on the valve If solder connections are used, use care to see that valve
is not overheated CAUTION! Overheating will damage the valve Clean all foreign material from the pipe and threads
before making final connections ' ' ■ ' ■
IMPORTANT:
ILIRN ON THE WATER SUPPLY CHECK ALL PLUMBING AND DISHWASHER CONNECTIONS FOR WATER
leaks '' ~ ^ ^ ^ ^ '
WARNING!
Do not leave line pressure to the water valve in freezing temperatures during construction, remodeling, etc Do not
use the drain hose supplied with the dishwasher for the water supply line It is not a reinforced hose and will burst
under water line pressure
■
1 2