Kenmore 808353 - Manual (Page 43)

J
Motor Inst alia l ton
1, Place motor on floor in proper position benealfi mounting hole in tub (See Figure39| (Pump housing and gasket
attached to motor}
2. Insert 2 guide pins" through mounting holes in tub and into corresponding attach screw holes in pump housing
"Guide pins are made by cutting 2 pieces of heavy gauge wire about 6' long. They are not required However,
they do simplify installation
GUIDE PINS !^'g DIA ROD
6' tONGl
UPPER IMPELLER
F I G U R E 3 9
3
Temporarily
attach upper impeller to motor shaft with screw.
4. Place gasket and cover ring over guide pins in position inside tub.
5. Grasp impeller and lift motor straight up into position beneath tub. (See Figure 39.)
6 Holding motor in position, install two of the attach screws directly across from each other,
7. Remove guide pins and upper impeller and complete installation of all attach screws
|<
Rernomg Pump and Motor Assembly (Manufactured in 2978 or Later)
The motor and pump assembly has been redesigned to allow removal through the inside of the tub It is important
that the following procedure be used to remove and replace this assembly.
1. Shut off electrical power to the dishwasher.
2. Remove access panel and toe plate
3. Disconnect hoses from pump housing ports,.
4. DtsconnecL motor electrical leads from terminal block and relay-
5. Remove the lower rack and lower spray arm,
6 Remove 6 pump mounting screws (Some housings may have 10 screws)
7 Separate halves of clamping ring from jHimp housing (access compartment), See Figure 40
8 Pump and motor assembly can now be lifted out from inside the tub.
4 0