Action – Kenmore 808353 User Manual

Page 91

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Drains or water syphons

out of dishwasher after

a fii! for either a wash

or rinse.

PROBLEIVl

1„ No loop in drain line. (Urtdercounter

Dishwashers!

POSSÍBLE CAUSE

2 . Drain line connected after "J" trap

{undercounter washers).

ACTION

1.

All draiii lines must have an elevated

loop. Refer to instaliation

instructions.

2, - Drains must be connected ahead of

"J" trap or into top end of a garbage

disposal. Refer to installation

instructiorrs.

Recirculating hose from pump to top

spray tube partially or totally

restricted.

3. Checi< circulation of water system.

Clear any restrictions or blockap.,

Main motor running in wrong direction

{start phase wires reversed at timer or

motor.

Dishwasher will not

drain.

NOTE; Approx. 2 pints

of water

Will

remain

in bottom of the tub.

1.

Drain port In pump castirsg totally

obstructed,

2.

Main motor won't run in clockwise

direction {open start phase winding).

3.

Vanes broken off the lower impeller.

4,

Refer to wiring diagram for proper

connections.

1,

Clean drain port If unable to clean,

replace casting.

2,

Refer to wiring diagram for pump out

period and check voltage to motor.

3,

Dismantle top section of pump

assembly — visually Inspect.

4,

Drain line kinked or collapsed (total

restriction).

4. Check drain line.

Open circuits between timer output

terminal and motor..

Refer to wiring diagram and check out

run and drain phase motor circuits for

loss of voltage.

B, Open timer contacts for motor start

and run windings.

Refer to wiring diagram for dosed

timer contact period. Check voltage

through timer for these periods.

Dishwasher does not

drain completely.

NOTE: Approx 2 pints

of water will remain in

the bottom of the tub,

which is a normal

condition.

1. Drain line too smali.

2 . Clogged coupler {portable model),

3,

Drain tine loop too far from dishwasher,

{Water drains back into dishwasher.

Long drain lines only.)

1.

The drain line must never be under

1/2 inch inside diameter.

2.

Visually inspect and clean.

3.

Loop must be close to dishwasher.

Refer to instailation instructions.

8 8

Advertising