Sharp cs-2850 - Manual (Page 6)

OPERATING CONTROLS
©
I
I ON
@ D=:
POWER SWITCH:
When the power switch is turned on, the calculator is ready for opera-
tion.
PRINT MODE SELECTOR:
“P" position: The calculator functions as a print/display calculator.
(Print mode}
position: The calculator functions as a display calculator. (Non-print
mode)
Mode change print:
When changing the print mode selector, the following print will appear.
" -P" (red print): When changing the selector from P to
“ * * •____ * * • -hP” (red print): When changing the selector from ♦ to
P.
I
5/4
ROUNDING SELECTOR:
— ♦ “t” position: An answer is rounded up.
“5/4” position: An answer is rounded off.
“i” position: An answer is rounded down.
EXAMPLE: 10,005 ^ 5 = 2.001
Set decimal to 2 , T
10.005 [±) 5 g] -»2 01=^
Set decimal to 2, 5/4
10.005 a 5 g] -^2 00 *
Note: The decimal point floats during successive calculation by the use
of ® or g] key.
In floating decimal point system, an answer is rounded down.
- F
—6
— 5
— A
— 3
— 2
— 1
—
0
DECIMAL SELECTOR:
Presets the number of decimal places in the answer.
In the “F" position, the answer is displayed in the floating decimal
system.
CONSTANT MODE SELECTOR:
“K" position: The following constant functions will be performed:
Multiplication: The calculator will automatically remember the first
number entered (the multiplicand) and the [x| in­
struction.