To return the appliance to manual operation – Kenwood SC102/2WH User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
B. TO SET THE TIMER TO SWITCH 'OFF' ONLY
Follow Points 1 -4 as above, then:
5. Set the cooking hours.
Push in the cooking hours button, at the
same time turn the setting knob until the
cooking time is entered in the display.
Release the button. The auto display will
glow, the cooking display will flash for a
few
seconds
and
will
then
glow
continuously.
6. Set the oven to the required
temperature.
The oven and fan neons should be on.
7. To check the stop time.
The stop time can be checked at any time
during the cooking period by pressing the
stop button. The stop time will be
displayed.
Notes:
1. The auto display will remain on during an automatically timed period.
2. The cooking display will glow whilst the oven is on.
3. The oven indicator neon will cycle on and off during the cooking time as usual.
4.
Once the controls have been set it is possible to check the times which have been set or the remaining cooking
time by pressing the appropriate button.
5.
A programme may be cancelled by returning the cooking hours to zero. Press the cooking hours button and at
the same time turn the setting knob to the left as far as possible and hold for a few seconds. Release all buttons. The
auto display will now flash. This acts as a reminder to reset the appliance to manual. Whilst cancelling an automatic
cycle the displays and audible signal should be ignored.
6.
The fan and fan on neons may continue to operate once the automatic cycle is completed, until the controls are
cool.
To Return the Appliance to Manual Operation
Follow the steps below to ensure that after use the oven is returned to Manual, otherwise
it will not operate.
At the end of a timed cooking operation
the auto display will flash.
The buzzer will sound for fifteen minutes.
To switch off press any button.
Turn the oven control to OFF position.
The auto display will continue to flash. The
fan may stop and the fan on neon may go
out. (Seenöte).
Turn the Manual/Automatic selector knob
to Manual.
The auto display will not flash.
Turn the oven control on to check that
the oven operates manually.
Turn the control OFF.
No indicator neons should operate.
Note:
The fan and fan on neon may continue to operate once the automatic cycle is completed, until the controls are cool.
When following any of the above charts it should be remembered that there may be some delay between the oven
being on and the fan beginning to operate.
12